
    The following is an algorythm, showing how to set an Amiga 2000 up to
properly use the IBM emulator MULTIDOS.

- unarc Multidos using LHA, onto a blank floppy.
- load the Multidos' mountlist into AZ (the editor).
- copy the section called MC0:, and the section called MC1: to the
hard drive's mountlist (tack them on the end).
- change MC1: to MC2:, and Units to 2.  This is because I have DF2: instead
of DF1:.
- save the new mountlist.

- copy multidosfilesystem from the floppy L: directory to the hard drive
L: directory.
- copy PCformat.spc from the floppy s: dir, to the hard drive s: directory.
- copy multidos.device from the floppy devs: dir, to the HD devs: dir.

- create a Multidos directory in the hard drive, and throw PCformat,
PCmountall, and PCkillall into this directory.

- to install the IBM emulation, type PCMOUNTALL from the CLI prompt.
- to remove the IBM emulation, type  PCKILLALL  from the CLI prompt.

NOTE:- IBM drive A: is labelled MC0:

ex) copy ibmfile.ext.com ram: (from IBM formatted disk).
    copy ram:ibmfile.ext MC0: (to AMIGA formatted blank).

That's it!  Remember, the floppy will always appear to be busy, because
the emulator doesn't know whether the disk to be inserted will be an IBM or
Amiga formatted disk.






